Effective tips on how to fix dents on aluminum trailer toolboxes

If you have a trailer in The United States of America, your investment in toolbox trailers can be significant. high-quality aluminum trailer toolboxes can run up to $500 or more. If you spend that kind of cash on a toolbox, you do not want to leave dents and scratches to damage your toolbox. There are a few things you can do if your toolbox is dented.

What to do if your toolbox is dented

The first thing is not to panic. There is a high possibility that you could get rid of dents from your aluminum trailer toolboxes easily and without damaging it further. We will explain a few things you can do when your toolbox sustains some dents. However, it is important to bear in mind that the steps we offer in this guide offer no guarantee that the procedures will work a hundred percent effectively. You should also bear in mind that you will need to be very careful when trying a quick fix to remove a dent from your toolbox. Otherwise, you might have to look for a replacement for your toolbox. Here are a few fixes to your dented toolbox.

Apply heat and force

While we all love aluminum toolboxes, it is important to understand that aluminum is a pliable metal that can get dented easily. A poor backing job or a wayward forklift can easily dent your aluminum toolbox in seconds. You should therefore attempt and get the dent out of your tool trailers for sale by force.

If you do your research online in America, you may come across tutorials that include pounding away on your toolbox using a hammer. You will need to use a hammer but what you do not need is to use brute force and keep pounding away at the toolbox to fix it. If the dent is not deep, a few strokes of a hammer could quickly do the job.

Step by step guide

If the dent is too deep to use a hammer, then you could make things easier. If you heat the metal using a blowtorch for about 3 minutes, you will reduce the chances of cracking or breaking the metal at the dent site.

You should take a blowtorch and heat up the metal at the car bumper gradually. You can heat up the area around half an inch around. Make sure the metal is hot and gently tap with a hammer to see how the metal responds. Increase the force of your hammer gradually until you start pushing the dent out. Depending on how severe the dent is, you may or may not continue heating as you hit the metal. You should be careful with this step to avoid damaging your toolbox.

What to keep in mind

When your aluminum trailer toolboxes trailers in America are damaged, you should avoid continually heating and cooling the metal to avoid damaging it. This will cause unnecessary stress and worsen the problem. You should keep a low flame as you pound out the dent than reheating the metal several times.